Paxton Automotive Universal Remote Novi 1200 User Manual download pdf (Page 13)

3-1

P/N: 4809658

23MAR06 v1.0 UnivSBMCarb(4809658v1.0)

Section 3

OIL FEED INSTALLATION

A. The supercharger uses engine oil for lubrica-

tion and must have an oil feed line connect-

ed to a filtered oil access on the engine.

B. Remove the 1/4"NPT oil pressure sending

unit from the engine block (next to the dis-

tributor). Install the supplied 1/4"NPT street

TEE into the block. Install the oil pressure

sender into the end of the TEE. Install the

1/4" x -4 fitting into the branch of the TEE.

Position the fitting so that the opening faces

the passenger’s side/rear of the engine. (See

Fig. 3.1-a.)

*** NOTE ***

Use clean engine oil on the pipe threads. Teflon tape

and sealant is NOT recommended as it might loosen

and cause blockage of the small oil feed orifice

resulting in supercharger failure.

C. Attach the 90° end of the supplied -4 braid-

ed oil feed line to the installed fitting. (See

Fig. 3.1-a.) Secure the hose with the tie-

wraps provided, routing it away from

exhaust heat, chafing and/or sharp objects.

Temporarily cover the open end from debris

until the connection is made to the super-

charger.

3.1 OIL FEED INSTALLATION

Fig 3.1-a.

FACTORY SENSOR

INSTALLED INTO SUPPLIED

STREET TEE

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

No comments

Paxton Automotive Universal Remote Novi 1200 User Manual Page 13