Paxton Automotive Automobile Parts 4809655 User Manual download pdf (Page 23)

P/N: 4809655

16AUG07 v1.0 96-03MusGT(4809655v1.0)

4-3

C. Attach the supplied K & N air filter, 3-1/2"

sleeve, 90° x 3-1/2" elbow and #56 hose

clamps to the MAF and secure.

*** NOTE ***

1996-2001 models use the 90° x 3-1/2" plastic inlet

elbow with the hole and grommet in the side. 2002+

models use the 90° x 3-1/2" plastic elbow without a

hole in the side. Both elbows have been supplied.

D. (1996-2001 Models only.) Insert the factory

air temperature sensor into the rubber grom-

met located on the side of the 90° elbow.

Lubricate for easier fit. (See Fig. 4.2-a.)

*** NOTE ***

2002-2003 models do not have a separate IAT

sensor.

E. From beneath the vehicle, remove the two

factory nuts and washers from the passenger’s

side lower fender valence. Mount the

MAF/bracket assembly onto the existing studs

using the same washers and nuts originally

removed.

F. Using a #52 hose clamp, connect the piece of

3-1/2" flex hose to the elbow attached to the

MAF meter and route it through the opening

in the right side inner fender toward the

supercharger. Make sure the 3-1/2" flex hose

does not contact or rub on the edge of the

inner fender opening. (Eventual hose failure

will result if the hose is not properly routed.)

G. Route the factory temperature sensor and

MAF sensor connectors out through the inner

fender opening. Reattach the connectors to the

relocated sensors.

H. Install the bypass valve assembly on the

underside of the secondary intake tube. (See

Fig. 4.2-c.) (See Appendix “J” for bypass

assembly procedure.)

Fig. 4.2-b

Fig. 4.2-c

ATTACH TO

DISCHARGE DUCT

I. Place the secondary intake tube/bypass valve

assembly on the supercharger inlet and attach

it to the flex hose. Attach the other end of the

bypass valve to the discharge tube. Connect

the hose that was previously installed on the

hard plastic crank case ventilation line to the

brass fitting on the intake tube. Tighten the

clamps. The finished installation appears as

shown. (See Fig 4.2-d.)

Fig. 4.2-d

BRASS FITTING TO

VALVE COVER VENT

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 51 52

Comments to this Manuals

No comments

Paxton Automotive Automobile Parts 4809655 User Manual Page 23

Comments to this Manuals

Related products and manuals for Toys & accessories Paxton Automotive Automobile Parts 4809655